Access Point Cisco 1852i Aironet WiFi Wireless AIR-AP1852I-A-K9

Access Point Cisco 1852i Aironet WiFi Wireless AIR-AP1852I-A-K9. Tipo Interior. WiFi 802.11ac. Wave 2 1.7Gbps. MINO 4x4: 4SS. Antenas internas 5dBi. 2 puertos Lan Gigabit (1x PoE.) Garantia 3 meses directamente de Cisco en centros de servicio autorizados a nivel nacional.

ESPECIFICACIONES TECNICAS:

General

• Device Type: Wireless Access Point - Indoor
• Wi-Fi Standard: 802.11ac Wave 2
• Ram Memory: 1 GB
• Flash Memory: 256 MB
• Radios: Dual 2.4 GHz and 5 GHz, up to 80 MHz maximum bandwidth
• Maximum PHY data rate: Total aggregate maximum PHY rate = 1950 Mbps (1733 Mbps 5GHz + 217 Mbps 2.4GHz)
• MIMO radio design: Spatial Streams: 2.4GHz: 3x4:3SS SU-MIMO / 5GHz: 4x4:4SS SU-MIMO, 4x4:3SS MU-MIMO
• Associated clients: 200 per radio, 400 maximum per access point
• Beamforming: Transmit beamforming
• Status LED indicates: boot loader status, association status, operating status, boot loader warnings, boot loader errors
• Dimensions (W x L x H): 210.8 x 210.8 x 50.8 mm
• Weight: 3.12 lb (1.41 kg) 

Networking

• Connectivity Technology: Wireless
• Data Transfer Rate: 1.7 Gbps
• Form Factor: External
• Power Over Ethernet (PoE): PoE+
• Status Indicators: Status
• Wi-Fi Bands: 2.4 GHz, 5 GHz
• Wireless Protocol: 802.11a/b/g/n/ac (draft 5.0)
• Data Link Protocol: IEEE 802.11a, IEEE 802.11ac (draft 5.0), IEEE 802.11b, IEEE 802.11g, IEEE 802.11n
• Compliant Standards: IEEE 802.11a, IEEE 802.11ac (draft 5.0), IEEE 802.11b, IEEE 802.11d, IEEE 802.11g, IEEE 802.11h, IEEE 802.11i, IEEE 802.11n, IEEE 802.1x, IEEE 802.3ad (LACP), IEEE 802.3af, IEEE 802.3at 

Software

• Cisco Unified Wireless Network Software Release with AirOS wireless controllers: 8.1 MR1 or later for the Cisco Aironet 1850 Series Access Points 

Deployment modes

• Centralized local
• Standalone
• Sniffer
• Cisco FlexConnect™
• Monitor
• OfficeExtend
• Mesh 

Wireless LAN controllers Supported

• Cisco 2500 Series Wireless Controllers
• Cisco 5500 Series Wireless Controllers
• Cisco 5760 Series Wireless Controllers**
• Cisco Flex® 7500 Series Wireless Controllers
• Cisco 8500 Series Wireless Controllers
• Cisco Virtual Wireless Controller**
• Cisco Wireless Controller Module for ISR G2
• Cisco Catalyst 3650/3850 Series switch with integrated controller**
• Cisco Wireless Services Module 2 (WiSM2) for Catalyst® 6500 Series Switches
• Cisco Mobility Express 

Integrated antenna

• 4 GHz, gain 3 dBi, internal omni, horizontal beamwidth 360°
• 5 GHz, gain 5 dBi, internal omni, horizontal beamwidth 360° 

External antenna (sold separately)

• Certified for use with antenna gains up to 6 dBi (2.4 GHz and 5 GHz)
• Cisco offers the industry's broadest selection ofantennas, delivering optimal coverage for a variety of deployment scenarios 

Interfaces

• 1 x 10/100/1000BASE-T autosensing (RJ-45), Power over Ethernet (PoE)
• 1 x 10/100/1000BASE-T autosensing (RJ-45), AUX (used for Link Aggregation)
• 1 x Management console port (RJ-45)
• 1 x USB 2.0 (enabled via future software) 

Power - Requirements

• Input: 44 to 57 VDC
• Power supply and power injector: 100 to 240 VAC; 50 to 60 Hz
• Power Draw: 20.9W - Note: When deployed using a Power over Ethernet (PoE) specification, the power drawn from the power sourcing equipment will be higher by some amount, depending on the length of the interconnecting cable. 

Power - Options

• 3at
• Enhanced PoE
• Cisco power injector, AIR-PWRINJ4=
• Cisco local power supply, AIR-PWR-C=
• Cisco power injector, AIR-PWRINJ5= (Note: this injector supports 802.3af only)
• 3af - Note: If 802.3af PoE is the source of power,(1) the 1852e 2.4-GHz radio will shift to 2x3 from 3x4,(2)The USB port and AUX Ethernet port are disabled on both the 1852i and 1852e. 

Environment - Cisco Aironet 1850i

• Nonoperating (storage) temperature: -22° to 158°F (-30° to 70°C)
• Nonoperating (storage) altitude test: 25˚C, 15,000 ft.
• Operating temperature: 32° to 104°F (0° to 40°C)
• Operating humidity: 10% to 90% (noncondensing)
• Operating altitude test: 40˚C, 9843 ft.